airbag

[fipatti]

Tervehdys fiatistit. Stlossa palaa edelleen oikeanpuolen airbag valo.Penkin alta, takaluukusta ja hansikaslokerosta tehty jo aiemmin uudet liitokset.Missä vika?
Multiecu antoi tälläisiä viankorjaus ohjeita:

1. The code is set when the ECU Supply Voltage is out of the specified range longer than allowed.
Certain system clear this code at the next start after the voltage is OK.
Check the ECU supply circuit and ECU ground.
Check also:
- Alternator, diode pattern, battery, pole and cable condition, good ground connections between alternator, engine, chassis and battery negative pole.
The reason for this fault is Value too low
The current status of the fault is Intermittent
The error counter value is 160


2. The ECU detected a short to Ground or Battery + in the Side Airbag Squib circuit(s) as indicated by the code.
ATTENTION! TURN THE KEY OFF FOR AT LEAST 10 MINUTES, THEN DISCONNECT THE BATTERY AND WAIT FOR 15 MINUTES, THEN DISCONNECT THE AIRBAGS.
After disconnecting the Airbags, inspect the wiring for the short, and replace the harness if faulty.
NOTE: In some cases the code may refer to both driver and passenger side Squib circuits, or to a defect in the ECU itself.
After completing the test and replacing the faulty parts, assemble the system and reconnect the battery as the last step. After that, read the codes and data again to ensure the system to be OK
The reason for this fault is Open circuit
The current status of the fault is Intermittent / Present
The error counter value is 170

3. The ECU detected a short to Ground or Battery + in the Side Airbag Squib circuit(s) as indicated by the code.
ATTENTION! TURN THE KEY OFF FOR AT LEAST 10 MINUTES, THEN DISCONNECT THE BATTERY AND WAIT FOR 15 MINUTES, THEN DISCONNECT THE AIRBAGS.
After disconnecting the Airbags, inspect the wiring for the short, and replace the harness if faulty.
NOTE: In some cases the code may refer to both driver and passenger side Squib circuits, or to a defect in the ECU itself.
After completing the test and replacing the faulty parts, assemble the system and reconnect the battery as the last step. After that, read the codes and data again to ensure the system to be OK
The reason for this fault is Value too high
The current status of the fault is Intermittent
The error counter value is 147

4. No help available
The reason for this fault is Interference detected / Faulty signal
The current status of the fault is Intermittent
The error counter value is 8

[fipatti]

Tuollaiset vikakoodit:

3c-front crash sensor, interference detected/faulty signal, 8
0E-side airbag(driver) , value too hight, 147
0E-side airbag(driver) , Open circuit intermittent/present , 170
02-control unit power supply , value too low , intermittent, 160

Mitähän tässä pitäisi sitten tehdä?

[Luigi]

Onkohan akku kuinka vanha? Stilon systeemit ei pidä yhtään alijännitteestä, ja alkavat pukata satunnaisia virhekoodeja.

[fipatti]

Missä sijaitsee airbagin ecu stilossa?

[matti]

Lämmityslaitteen ala puolella, jalkatilan sivumuovit pois ni pääsee käsiksi.. Äänieristys materiaalin alla on se rasia..

Miulla on yksi toimiva boxi ylimääräsenä, jos tarvetta tulee.. (c404)

[fipatti]

Kiitos,
Pitää alkuviikosta katella.

[fipatti]

Pitääkö airbag boxin vaihdon jälkeen käyttää ohjelmoinmissa korjaamolla